«

[slx]

I have a problem after the start with the fable.exe.
It happens with different sound setting and both with the FD and the CD versions too.
I changed the CPU settings of the DOSBOX (to 386 and 486) but it still gives the same error:

DOS/4GW error (2001): exception 00h (divide by zero) at 160:00000410
RSF32: prev_tsf32 52A4
SS 168 DS 168 ED 168 FS 0 GS 20
EAX 15E47C00 EBX 238CD0 ECX 1C0F90 EDX 1
ESI 1 EDI 1602F352 EBP 23855A ESP 23741A
CS:IP 160:00000410 ID 00 COD 15E47C00 FLG 46
CS= 160, USE32, page granular, limit FFFFFFFF, base 0, acc CF9A
SS= 168, USE32, page granular, limit FFFFFFFF, base 0, acc CF92
DS= 168, USE32, page granular, limit FFFFFFFF, base 0, acc CF92
ES= 168, USE32, page granular, limit FFFFFFFF, base 0, acc CF92
FS= 0, USE16, byte granular, limit 0, base 14, acc 0
GS= 20, USE16, byte granular, limit FFFF, base 25C0, acc 93
CR0: PG:0 ET:0 TS:0 EM:0 MP:0 PE:1 CR2: 0 CR3: 0
Crash address (unrelocated) = 2:00000410

[zirkoni]

Maybe CPU too fast? Try setting a fixed cycles count (~10k). Also you can try replacing DOS4GW.EXE with dos32a.exe

[slx]

Originally Posted by zirkoni

Maybe CPU too fast? Try setting a fixed cycles count (~10k). Also you can try replacing DOS4GW.EXE with dos32a.exe

Thank you for your answer!
It was set to 6000 cycles with 386 and 486 setting but it did not work with non of them. Where can I get dos32a.exe? There is no on the Fable CD.

[slx]

This error happens with the 'svga_et3000' and 'svga_et4000' settings.
It works with the 'svga_s3' setting.